v2.5 [Apr 12, 2013]
1. AM335x device now has separate selections for silicon Rev 1.x and Rev 2.x.
2. For AM335x change configuration xml file to not convert signal names in GUI to upper case or lower case. Allow mixed case to show as in the data manual.
3. Changed criteria for dropping a device pad from "blank pad config register name" to "blank register offset". This is because am335x does not have the register name column and needs to remove device pads where the pad config registers are not implemented.
4. Set data grid view property AutoSizeRowsMode = AllCells. This was because with lower case signal names the part of the letters that extend below the bottom line get cut off. Fixed window resizing for the Interface View case. Use Rows[0].height instead of RowTemplate.height.
5. Added support for signals having multiple interface names. This happens if there is an additional mux control in the IP block.
6. Added code to insert status msgs like this in the generated board-dependent C header file .
You can graphically configure the device peripherals intuitively and rapidly.
